Production
|
Recently acquired, a state-of-the-art paint booth has enabled us to perform all painting in-house increasing quality and dependability.
Lockheed Martin has granted MIL-F-18264D Painting Approval
|
| Nor-Ral Plastics' personnel utilize many years of industry experience and take pride in their workmanship to manufacture product of the highest quality. Listed below is a sampling of production capabilities: |
- Wet lay-up using the latest materials available
- Clean room controlled prepreg lay-up utilizing fiberglass, carbon, kevlar, and other fabrics
- Use of core reinforcement as required within the lay-up processes
- Autoclave curing,
7'x12'; 350°F 110psi
- Oven curing,
7'x12'x 6-1/2' Walk-In; 500°F Gas Fired
- Routing and trimming using special tooling to maintain quality and precision
- Detail assembly using holding fixtures and jigs
|
| Because of our highly qualified staff and short production runs, Nor-Ral has the ability to quickly adapt to any production requirement and manufacture product to accommodate many special needs such as in an "Aircraft on Ground" situation. |
Roberto puts finishing touches on a tool in the production process
|
|
Management personnel participate in part production to investigate techniques and process improvement areas to aid manufacturing.
Chip sands a thermoplastic cover in preparation for adhesive application.
|
Sean cleans a part after being taken from the two piece mold. |
| |
| |
